Notes on silicone rubber molds
Release time:
2023-02-21 13:37
1, b component is a catalyst, easy to moisture hydrolysis, so the lid should be used after the cover tightly.
2, a, b group once mixed, chemical reaction; immediately start, viscosity gradually rise, can not be suspended, in order to avoid waste, should be used according to the amount, with the match, should be used immediately after the match, can not be delayed.
3, a, b group ratio, related to the speed of the chemical reaction and the performance of the mold. b component more, the faster the reaction, the higher the strength and hardness of the product, but the toughness with the reduction, therefore, weighing requirements are accurate.
4、 Before preparation, the a component material should be stirred up and down evenly, and then weighed.
5、 The pouring method is suitable for the relief class, and the painting method is suitable for the production of three-dimensional class molds. Pouring relief class mold should be made first length and width are larger than the original carving length and width of 4-6cm border. The border should be flat and the inner surface should be smooth. When pouring, place the frame on a clean glass plate, and then place the original in the frame, leaving a gap of 2-3cm on each side.
Related news
Method of making mold filling and splitting mold of mold silicone
How to make a piece mold or sheet mold: Apply the vacuumed silicone by brush or infusion method. If you are making a piece of mold or a piece of mold with the brush method, brush the product or model you want to copy with a layer of release agent or isolation agent before painting
Because unsaturated resin and resin products with peroxide curing agent after the reaction of resin will generate a lot of heat, the general resin curing time of 3 minutes, so 3 minutes after the mold as soon as possible, in order to prevent the silicone mold will not produce the phenomenon of burning mold.
Why does mold silicone have a low number of mold turnovers?
In the process of making the mold added too much silicone oil, silicone oil destroyed the molecular weight of silica gel, so the mold will appear to turn the mold less times not durable and other phenomena. If it is said to do small products with more complex patterns
The process of making silicone molds
The choice of the form of mold opening and the choice of mold line is very important, one is for the convenience of taking the mold, the second is that the mold line should be selected in a way that does not affect the overall effect of the product, the third is not to affect the quality of the product
Raw material of silicone mould
Silicone is becoming more and more popular because of its environmental performance, to understand the knowledge of silicone molds, we have to start from the silicone raw materials.
Notes on silicone rubber molds
b component is a catalyst, easy to moisture hydrolysis, so the lid should be used after the cover tightly.
Dongguan tianhui new Material Co., Ltd.
Silicone Ink for Fabric Filling
Copyright © 2023 Dongguan tianhui new Material Co., Ltd. | SEO Powered by:www.300.cn dongguan.300.cn